|
350BBLMud System
This unit consists of a skid mounted mud tank with equipment to
mix and clean drilling mud. The pump will be controlled from a
panel on the front porch, the mixers and shaker will be controlled
from remote stations mounted near each unit. There are three
guidable 3” mud guns to facilitate mud suspension. This unit has
two separate weirs for fluid control. The first weir is near the shak-
er and is an over flow/flow thru type. The remaining weir is on the
opposite end and is a flow thru type.
Specifications
-
Nominal Physical Dimensions:
Height 10 ft
Width 11 ft 1 in
Length 45 ft
-
Tank Specification:
Three beam skid construction
with a 94in. outside dimension.
Sloped Floor
Top rail height 64 in/60 in
Three compartments, each
end has a 65 BBLcompartment
and a 190 BBLcompartment in the middle.
Three removable manways are flush with
grating and have internal ladder rungs.
Swing gate in handrail to allow placement of
material to be loaded into the shredding hopper,
which is mounted on the top deck.
-
Pump Specification:
6 x 5 x 14RH
Model 250
Impeller Diameter 11
Electric Motor 50 HPBaldor
Power 230/460V-3Ph-60Hz
-
Shaker Specification:
Model 2-PANEL-1560052147
Motor (2) 1 1/2 HP
Power - 230/460V-3Ph-60Hz
-
Specification:
Mac 2000
Model M2A10-C
Electric Motor 10 HPBaldor
Mixer Paddle 4 Blade with 36” Diameter
-
Electrical Control Specification:
Centralized Power Disconnect and Control
Panels
Remote Operation Motor Control near each
component on top deck.
-
Piping Specification:
Drainage (4) 8” Sump drains with butterfly
valves
Exterior Suction (2) 6” Suction lines with
butterfly valves
Pump Suction (2) 6” Suction lines from first
and second compartments
Pump Feed (2) 6” Feed lines into first and
second compartments
Pump Feed (3) 3” guidable mud guns. One is in
the first compartment, and the other two are in
second compartment
|
